The new ONE BLACK by Salvatore
ONE BLACK
Commercial 58mm Brew Group with Thermal Siphon This group is made of chrome plated brass with maximum heat stability and thermo siphon.
The Group Valve The three-way solenoid valve is a commercial valve that relieves the water pressure and water immediately when brewing is finished. This serves two functions; it dries the coffee grounds so they become like a cookie thus makes it easy to knock the coffee out of the portafilter with one knock (no rinsing and cleaning between brews).
Sirai Commercial Pressure Stat
The boiler temperature and pressure is regulated by an adjustable heavy duty commercial Sirai pressure stat
No significant interactions were observed when sildenafil (50 mg) was co-administered with acetyl salicylic acid (100 mg or 150 mg), antacid (magnesium hydroxide/aluminium hydroxide), and alcohol (mean maximum blood alcohol levels of 80 mg/dl).perceptions should also be sought since they may have an cialis for sale.
. 12 times the size of other machines. Its sensor turns on and off the heating element to insure correct temperature and pressure is maintained
Salvatore tried the pressure stats found in the Livia, Wega, Giotto, La Scala, Silvia, Expobar, BezzeraBZ02 etcetera and after much testing, disappointment and frustration he went back to the reliable, quality, heavy duty commercial more expensive Sirai.
It carries a lifetime warranty and is on all Salvatore’s espresso machines.
Brewing
The brewing is activated by pressing a button on and then pressing it again to stop the brewing.
Boiler
1.5 liter 1/8 “ Thick wall copper boiler with a lifetime warranty. 1/2” brass top and bottom with a 1.5 “ diameter heat exchange for brewing and steaming at the same time, 1500 watt heating element.
Pressure Gauge
The pressure gauge will let you know when the boiler is up to pressure and temperature.
Pressure Relief Valve
This safety device will relieve excess boiler pressure if for any reason the boiler begins to overheat.
Electronic Controls
The water level in the boiler is controlled by an electronic water level probe . This control is hooked up to sensors in the boiler and when the water level in the boiler is low it turns the pump on to fill the boiler. This is called an autofil system.
Cup Warmer
Extracting the espresso into a warm cup is a must for the best result, this machine will keeps your cups warm on top of the machine
Hot Water Dispenser
The hot water wand is located on the right hand side of the machine. Just open the knob and hot water will be delivered through the wand.
Steam Wand
The steam wand is mounted on a ball joint that swivels 360 degrees.
Water Reservoir
The espresso machine has a 64 oz. water reservoir that has a machined signature screw cap. This machine cannot be plumbed in.
The Body of the Espresso Machine
The frame is made of heavy-duty steel that is powder coated for rust resistance. The cup warmer signature top and the drip tray and grill is 22 gauge brushed stainless steel. The body is black gloss powder coated for ease of cleaning and durability.
Maintenance
It is recommended using filtered water like bottled water, flush the steam wand after frothing the milk by opening the knob let a small amount of steam out then close the knob. Cleaning the brew group, the backflushing proceedure will remove old coffee grounds keeping your coffee tasting fresh and the valve clean so that it functions properly.
Accessories
Stainless 20oz steam pitcher, tamper, cleaning and backflush kit (esp cleaner, brush, blind filter basket) portafilter of choice (naked,single or double with 3 filter baskets, single, double and triple.
Dimensions: 13″ tall x 10.5” wide x 15” deep 110v 13.5 amps
CLICK HERE FOR MORE VIEWS
CLICK HERE FOR INSIDE VIEWS
Further information: www.salvatore-espresso.com
Quelle: www.salvatore-espresso.com
